en:bpi-r2:lede
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:bpi-r2:lede [2018/01/16 10:37] – frank | en:bpi-r2:lede [2023/06/08 17:06] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== LEDE (OpenWRT) ====== | ||
+ | * [[https:// | ||
+ | * [[http:// | ||
+ | * [[http:// | ||
+ | |||
+ | <code bash> | ||
+ | git clone https:// | ||
+ | cd bpi-r2_lede/ | ||
+ | git checkout bpi-r2-on-lede-v1 | ||
+ | make menuconfig | ||
+ | </ | ||
+ | here " | ||
+ | |||
+ | build with: | ||
+ | <code bash> | ||
+ | make -j1 V=s | ||
+ | </ | ||
+ | |||
+ | nach dem kompilieren liegen 2 img-Dateien im Ordner build_dir/ | ||
+ | <code bash> | ||
+ | frank@Frank-Laptop:/ | ||
+ | -rw-r--r-- 1 frank frank 67M Jan 16 12:03 build_dir/ | ||
+ | -rw-r--r-- 1 frank frank 67M Jan 16 12:03 build_dir/ | ||
+ | </ | ||
+ | |||
+ | img-files are on my [[https:// | ||
+ | |||
+ | Please note that lede currently not support hdmi-output (you will see only a purple screen). | ||
+ | ===== SD ===== | ||
+ | |||
+ | dd if=mtk-bpi-r2-SD.img of=/dev/sdx | ||
+ | |||
+ | |||
+ | ===== EMMC ===== | ||
+ | |||
+ | - Copy EMMC image to a running system which is on SD card | ||
+ | - start system and look which mmcblk is the emmc: cat / | ||
+ | - flash EMMC image to User Data Area of EMMC: dd if=mtk-bpi-r2-EMMC.img of=/ | ||
+ | - Unlock EMMC boot0 block: echo 0 > / | ||
+ | - flash preloader to EMMC boot0 block: dd if=mtk-bpi-r2-EMMC.img of=/ | ||
+ | - Change the Partition configurion of EMMC to 48h: reboot the system which is running | ||
+ | - Power off, remove SD card, and then power on R2 board. | ||
+ | |||
+ | |||
+ | ===== Network-configuration ===== | ||
+ | |||
+ | By default lan-ports are bridged together with IP-address 192.168.1.1 | ||
+ | |||
+ | Further configuration see here: | ||
+ | https:// |